Product ID:ENVIRO-BOND 300
MSDS Date:08/08/1990
FSC:8040
NIIN:00N056739
MSDS Number: BWLWP

Emergency Phone: 616-267-5021

Info Phone: 616-267-5021

Cage: PETRL

Telephone: 616-267-5021

Cage: PETRL

NON-HAZARDOUS INGREDIENTS

OSHA PEL N/K

ACGIH TLV: N/K

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:THIS PRODUCT HAS BEEN DETERMINED TO BE
NON-HAZARDOUS I/A/W 29 CFR 1910.1200. HOWEVER, AS WITH ANY
CHEMICAL, THIS PRODCUT SHOULD BE HANDLED W/GOOD INDUSTRIAL HYGIENE,
AND SAFETY PRACTICES AS SET FORTH IN THIS MATERIAL DATA SHEET.
EFFECTS OFOVEREXPOSURE:NOT APPLICABLE.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHAL:REMOVE TO FRESH AIR. SUPPORT BREATHING (GIVE O*2/ARTF
RESP) . SKIN:FLUSH W/COPIOUS AMOUNTS OF WATER. CALL MD . EYES:FLUSH
WITH CLEAR CLEAN WATER FOR @ LEAST 15 MINUTES TO REMOVE PROD UCT.
INGEST:GIVE EMETIC AND SEEK MEDICAL ADVICE.

Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:VERY LOW RISK.

Spill Release Procedures:SPILLS OF DRY PROD PRESENT SLIP HAZ WHEN WET &
SHOULD BE CLEANED UP IMMED. DO NOT WET SPILLS OF DRY PROD. SWEEP UP
DRY & FLUSH SPILL AREA W/WATER. SPILLS OF DILUTE SOLNS MAY BE
FLUSHED W/COPIOUS AMTS OF WATER, OR ALTERNATELY, THEY MAY BE
(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DUST GENERATED IN HNDLG OF THIS PROD
CAN BE EXPLO IF SUFFICIENT QTYS ARE MIXED W/AIR, IN WHICH CASE
IGNIT SOURCES SHOULD BE AVOIDED.
Other Precautions:PRODUCT MAY CREATE SLIP HAZARD WHEN MIXED WITH WATER.
SPILLS SHOULD BE DEALT WITH IMMEDIATELY.

Respiratory Protection:NORMALLY NOT NEEDED, BUT USE NIOSH/MSHA APPROVED
DUST MASK IF NEEDED TO PREVENT INHALATION OF AIRBORNE PARTICLES.
Ventilation:PROVIDE ADEQUATE VENTILATION TO MINIMIZE DUST INHALATION.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD SPLASH GOGGLES & (SUP DATA)
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
RELEASE PROC:ABSORBED WITH AN INERT MATERIAL SUCH AS EARTH OR
SPEEDI-DRY AND CONTAINED FOR DISPOSAL. EYE PROTECTION:FACE SHIELD .

Evaporation Rate & Reference:NOT KNOWN
Solubility in Water:NOT KNOWN
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDANTS.
Stability Condition to Avoid:THIS PROD IS STABLE & WILL NOT REACT
VIOLENTLY.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.

Waste Disposal Methods:DISPOSAL MUST BE I/A/W FEDERAL, STATE & LOCAL
REGULATIONS .

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.